Dyno information:

Dynojet 424xLC Chassis Dyno:
• Inertia dyno measures HP and Torque via acceleration of a fixed mass roller.
• Maximum axle weight 4000lbs
• Maximum vehicle weight 10,000lbs
• Maximum HP measurement 2000+ wheel horsepower
• Maximum Torque measruement 2000+ ftlbs. wheel torque
• Maximum speed 200mph
• Maximum wheelbase forward in 2WD: 172" (reverse running or backing onto the dyno can accommodate longer wheel bases for 2WD)
• Wheelbase range for AWD: 93-113"
• AWD setup: 2 unlinked dyno rollers set at 101" center to center spacing unlinked and fixed position
• inductive RPM pickup for spark-ignition engines
• Wideband Air/Fuel ratio monitoring via tail pipe probe or installing sensor into bung in exhaust
• Optical RPM pickup for diesel application testing
• Set up for drive on and over in either front wheel drive or rear wheel drive or AWD
• Ramp angle 5 degrees to accommodate extremely low vehicles
• Eddy Brake load control on rear roller only for steady state load tuning